Common faults and solutions for ice making machines

Summer is here, and the frequency of use of the ice machine is also higher. It is inevitable that there will be some failures. Those who open a store must understand the relevant equipment and learn simple troubleshooting.
Common faults and solutions for ice making machines
No ice
1. Not placed horizontally-it is required to be placed horizontally
2. The ice plate probe is faulty or too close-replace or adjust the ice plate probe
3. Whether the solenoid valve is leaking-replace the solenoid valve and filter
4. Refrigerant leakage-check for leaks and repair welding and vacuum to add refrigerant
loud noise
1. The fan is noisy-check the fan blades, install screws, correct or tighten
2. Whether the chassis is deformed-adjust
3. The compressor itself is noisy-adjust and replace
4. Refrigeration system pipeline matcha-adjust the route of the pipe
There is ice in the upper part of the ice tray but no ice or thin ice in the lower part
1. The ice tray installation is too inclined-adjust the installation
2. Fewer types of refrigerating species-add refrigerating species appropriately after determining the refrigerating species
3. Not placed horizontally-placed horizontally
The compressor does not start
1. Low voltage-adjust the voltage
2. Check the start protector-replace if damaged
3. Whether the compressor is normal-replace the compressor if it is abnormal
Insufficient heat dissipation
1. No ventilation-adjust the position of the vent
2. The condenser is dirty-clean the condenser
No water
1. The water inlet valve is blocked-clean the net cover (according to the water dispenser filter)
2. The inlet valve is broken-replace the inlet valve
3. The socket at the circuit board is loose or the circuit board is broken-check the circuit board, or replace the circuit board
4. The water level sensor switch is broken-replace the water level sensor switch
5. The ice baffle is not returning properly-adjust