What are the guidelines for installation and commissioning of ice machines and the installation service process

The ice maker is best installed in a well-ventilated place without direct sunlight. The minimum ventilation distance of the ice machine condenser is at least 1 meter away from the shelter, and the height is at least 50cm away from the roof. It is better to have a larger ventilation distance and keep the air flowing. The installation floor should be kept level, otherwise the operation of the machine will cause the water in the storage bin to affect the quality of the ice produced. After installation, first check the appearance integrity of the machine, whether the ice-falling channel is unobstructed, whether the fan blade rotates flexibly, whether all the shut-off valves of the unit are all opened, whether there is oil stains around the welding joints of the unit, and whether the compressor is short of oil.

YT-E-006 2.5L 150W Round Ice In Bullet Shape Ice Maker


Shuang reminds everyone that oil is closely related to the life of the compressor. You should always check the oil level and the color of the oil. Turn on the water source and check whether the water pressure is normal. If the water pressure is too low, the machine will keep alarming. It is recommended to use a water storage tank and a booster pump if the water is often stopped. The water level of the water inlet tank should be about 10 mm lower than the overflow port, and the water level can be adjusted by the floating ball.

Also don't forget to check the voltage, the ice maker has its own separate water valve and power supply for future maintenance. Do not make ice immediately after the ice maker is powered on. First let the crankcase heater press the oil to warm it up, and then let the unit run. Listen to the sound of the unit running here, and check the freezing condition of the evaporator. Some ice machines need to add salt water. Yes, generally a 30kg bucket with more than 200 grams of salt is the most suitable, and at the same time, check whether the water level of the water separator is normal.

After the unit is running normally, we also need to test some protection functions of the unit. Water shortage protection. When the machine stops, under normal circumstances, the unit can stop by blocking the switch with your hand for three minutes. At present, the ice maker always stops the compressor first, and then stops the ice blade after two minutes, which is beneficial to the next start-up, so that the ice in the entire ice bucket can be scraped off to facilitate the thickness of the ice in the next start-up.